There is a bolt behind the door handle lever to remove the door panel. The "bucket" has to be removed,that is behind the silver door handle lever to get to that bolt.
Basically there should be a cover behind the handle that pops off , and then you can gain access to the bolt behind it ,remove this bolt behind the cover.
Right next to the power mirror switch there is a one by three silver cover , this cover pops off and there is a bolt behind it .
Remove the three screws along the edge of the door panel, the bolt under the power window switches and the one behind the silver cover. That needs to pull up on the door to remove.
How to wire new Radio on 1990 Toyota Celica?
Radio Stereo Wiring Diagram for 1991 Chevy 1500?
How to remove radio on Acura Car models?
Where is Radio Fuse located on 2007 Dodge charger?
How to reset Radio code after car battery is died?
Can car radio code block Passkey anti theft system ?
After Market Stereo wiring for 1999 Chevrolet Silverado 1500?
Chevy car radio doesn't allow to switch to the XM Band to get the radio ID?
No power to radio on 2005
Lexus rx330 Radio has power but no sound?
http://repairhelpcenter.blogspot.com/2012/01/lexus-rx330-radio-has-power-but-no.html
Car only starts when gas pedal is pressed?
http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html
Hyundai coupe f2 hazard fault?
http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html
Where is the bulb located in glove box?
http://repairhelpcenter.blogspot.com/2012/01/where-is-bulb-located-in-glove-box.html
Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012
http://repairhelpcenter.blogspot.com/2012/01/additional-wiring-harness-needs-to-be.html
Fail smog test due to gas filter hose?
http://repairhelpcenter.blogspot.com/2012/01/fail-smog-test-due-to-gas-filter-hose.html
Clutch squeaking under hood?
http://repairhelpcenter.blogspot.com/2012/01/clutch-squeaking-under-hood.html
Replace door stay assemblies on
http://repairhelpcenter.blogspot.com/2012/01/replace-door-stay-assemblies-on-toyota.html
Acceleration lag problem?
http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html
How to Replace rear quarter glass on
http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-rear-quarter-glass-on.html
Overdrive light in the dash blinks?
http://repairhelpcenter.blogspot.com/2012/01/overdrive-light-in-dash-blinks.html
How to bypass immobiliser on Rover 200?
http://technoanswers.blogspot.com/2012/01/how-to-bypass-immobiliser-on-rover-200.html
Hood clear coat peeling off?
http://repairhelpcenter.blogspot.com/2012/01/hood-clear-coat-peeling-off.html
Engine stumbles coming off idle when warm?
http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html
How to Refit Rear seat on Rover 600?
http://repairhelpcenter.blogspot.com/2012/01/how-to-refit-rear-seat-on-rover-600.html
Remove the three screws along the edge of the door panel, the bolt under the power window switches and the one behind the silver cover. That needs to pull up on the door to remove.
For more detailed description with proper diagram,see the details below :-------
Removal and Installation
MKX Vehicles
- Remove the front door switch panel.Disconnect the electrical connectors.
Edge Vehicles
- Remove the front door inside handle bezel.
All Vehicles
- Remove the window control switch.
- Remove the 2 front door trim panel bolts.
- Remove the 3 front door trim panel screws.
- Disengage the bottom of the door trim panel from the door.
- Pull outward on the trim panel to disengage the push pins and retaining clip from the door.
- Lift the top of the door trim panel edge upward and out of the beltline moulding.
- Lift the door trim panel up and off of the lock rod.
- Remove the front door trim panel.
- Disconnect the electrical connectors.
- Remove and discard the push pins.
- NOTE: Install new push pins.To install, reverse the removal procedure
Item | Part Number | Description |
---|---|---|
1 | - | Retaining clip (2 required) (part of 17D743 / 17D742) |
2 | 17D743 (RH) / 17D742 (LH) | Sail panel |
3 | 23942 (RH) / 23943 (LH) | Front door trim panel |
4 | 14528 (RH)/ 14527 (LH) | Front door switch panel (MKX vehicles) |
4 | 226A38 (RH) / 226A39 (LH) | Front door inside handle bezel (Edge vehicles) |
5 | W708268 | Front door trim panel bolt |
6 | 14528 (RH) / 14527 (LH) | Front door window control switch bezel |
7 | W708412 | Front door trim panel screw |
8 | W708268 | Front door trim panel bolt |
9 | W708412 | Front door trim panel screw (2 required) |
10 | W712793 | Grommet |
11 | W711513 | Push pin (2 required) |
12 | W711521 | Push pin (3 required) |
As you can clearly see there is door panel clips on the door , so start at the bottom and pry the door panel off.
This details will help you.
Thanks.
See below more related solved problems :----