Multiple possibilities can cause this :-----
There are a few possibilities here that it could be. We are going to need to run a few tests to see what is going on. Don't worry... these tests are really easy! I can walk you through this diagnoses.
The first thing we need to do it check the battery with a voltmeter. A fully charged battery must have enough cranking capacity to provide the starter motor and ignition system with enough power to start the engine over a broad range of ambient temperatures. Even if its charged, it could still be bad causing a no crank condition! I would rec to get it load tested at a shop or at a battery store. A battery load test will verify the actual cranking capability of the battery. This is the best test. Or you can take a voltmeter and put it on the battery and crank the engine over. (Be sure the battery has a full charge on it.) If the volts drop below 9.6, the battery is bad and needs to be replaced! Just be sure all cable connections are clean and tight. Not only at the battery, but on the starter, engine and frame! Positive side as well as the negative side.
If all checks out, make sure that you have battery voltage on both terminals of the starter when cranking. If full battery voltage (12.6 volts) is present and the starter is not working, then the starter is bad and will need to be replaced! Just be sure all fuses small regular and large size fuses are good under the hood, as well as inside the vehicle.
Freightliner fl112 fuse box diagram?
http://technoanswers.blogspot.com/2012/01/freightliner-fl112-fuse-box-diagram.html
Car will not turn the ignition to start?
http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html
Car only starts when gas pedal is pressed?
http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html
Hyundai coupe f2 hazard fault?
http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html
Where is the bulb located in glove box?
http://repairhelpcenter.blogspot.com/2012/01/where-is-bulb-located-in-glove-box.html
Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012
http://repairhelpcenter.blogspot.com/2012/01/additional-wiring-harness-needs-to-be.html
Fail smog test due to gas filter hose?
http://repairhelpcenter.blogspot.com/2012/01/fail-smog-test-due-to-gas-filter-hose.html
Clutch squeaking under hood?
http://repairhelpcenter.blogspot.com/2012/01/clutch-squeaking-under-hood.html
Replace door stay assemblies on
http://repairhelpcenter.blogspot.com/2012/01/replace-door-stay-assemblies-on-toyota.html
Acceleration lag problem?
http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html
How to Replace rear quarter glass on
http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-rear-quarter-glass-on.html
Overdrive light in the dash blinks?
http://repairhelpcenter.blogspot.com/2012/01/overdrive-light-in-dash-blinks.html
How to bypass immobiliser on Rover 200?
http://technoanswers.blogspot.com/2012/01/how-to-bypass-immobiliser-on-rover-200.html
Hood clear coat peeling off?
http://repairhelpcenter.blogspot.com/2012/01/hood-clear-coat-peeling-off.html
Engine stumbles coming off idle when warm?
http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html
How to Refit Rear seat on Rover 600?
http://repairhelpcenter.blogspot.com/2012/01/how-to-refit-rear-seat-on-rover-600.html
How to replace the speakers on 2011 Ford Edge?
http://technoanswers.blogspot.com/2012/01/how-to-replace-speakers-on-2011-ford.html
How to Remove Rear seat on Rover 600?
http://repairhelpcenter.blogspot.com/2012/01/there-are-3-10mm-bolts-at-back-of-seats.html
http://technoanswers.blogspot.com/2012/01/toyota-solara-rattling-in-rear.html
Parking light stay on constantly?
http://repairhelpcenter.blogspot.com/2012/01/parking-light-stay-on-constantly.html
Engine hard to start after gas refill?
http://repairhelpcenter.blogspot.com/2012/01/engine-hard-to-start-after-gas-refill.html
How to replace wheel bearing on Honda Civic?
http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-wheel-bearing-on-honda.html
There are a few possibilities here that it could be. We are going to need to run a few tests to see what is going on. Don't worry... these tests are really easy! I can walk you through this diagnoses.
The first thing we need to do it check the battery with a voltmeter. A fully charged battery must have enough cranking capacity to provide the starter motor and ignition system with enough power to start the engine over a broad range of ambient temperatures. Even if its charged, it could still be bad causing a no crank condition! I would rec to get it load tested at a shop or at a battery store. A battery load test will verify the actual cranking capability of the battery. This is the best test. Or you can take a voltmeter and put it on the battery and crank the engine over. (Be sure the battery has a full charge on it.) If the volts drop below 9.6, the battery is bad and needs to be replaced! Just be sure all cable connections are clean and tight. Not only at the battery, but on the starter, engine and frame! Positive side as well as the negative side.
If all checks out, make sure that you have battery voltage on both terminals of the starter when cranking. If full battery voltage (12.6 volts) is present and the starter is not working, then the starter is bad and will need to be replaced! Just be sure all fuses small regular and large size fuses are good under the hood, as well as inside the vehicle.
This will help.
Thanks.
See below latest solved solutions :----