The procedure to perform this job is as follows :-----
Where is MAF sensor located on 2000 Ford Expedition?
http://schematicsdiagram.blogspot.com/2011/12/where-is-maf-sensor-located-on-2000.html
Car won't start without hitting the gas pedal?
http://schematicsdiagram.blogspot.com/2011/12/car-wont-start-without-hitting-gas.html
Ford Keyless Remote Fob Reprogramming?
http://schematicsdiagram.blogspot.com/2011/12/ford-keyless-remote-fob-reprogramming.html
1995 Oldsmobile Eighty Eight has bad O2 Sensor?
http://schematicsdiagram.blogspot.com/2011/12/1995-oldsmobile-eighty-eight-has-bad-o2.html
Dual Exhaust on 1996 Chevrolet camaro z28?
http://schematicsdiagram.blogspot.com/2011/12/dual-exhaust-on-1996-chevrolet-camaro.html
How to replace TDM module to Pro module wiring ?
http://schematicsdiagram.blogspot.com/2012/01/how-to-replace-tdm-module-to-pro-module.html
4X4 Truck makes roaring noise in the front end?
http://schematicsdiagram.blogspot.com/2012/01/4x4-truck-makes-roaring-noise-in-front.html
Ford Freestyle second row seat will not fold?
http://technoanswers.blogspot.com/2012/01/ford-freestyle-second-row-seat-will-not.html
Front struts installing are bit longer?
http://schematicsdiagram.blogspot.com/2011/12/front-struts-installing-are-bit-longer.html
How to adjust rpm on 2009 dodge charger SRT8?
http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
No power to the control side of the fuel pump relay?
http://schematicsdiagram.blogspot.com/2011/12/no-power-to-control-side-of-fuel-pump.html
Heater fan and headlights will not turn off with ignition off?
http://technoanswers.blogspot.com/2012/01/heater-fan-and-headlights-will-not-turn.html
Car takes time to Crank and start?
http://howtobyme.blogspot.com/2011/12/car-takes-time-to-crank-and-start.html
Car jerks while going uphill and Check engine light is ON?
Car turns over, but only starts, if starter is jumped?
Vehicle will NOT NAVIGATE FROM TPM SCREEN TO MAIN MENU SCREEN?
http://schematicsdiagram.blogspot.com/2011/12/vehicle-will-not-navigate-from-tpm.html
Service Engine Soon light stays on?
Gasoline around gas cap?
Cruise control not working?
http://schematicsdiagram.blogspot.com/2011/12/cruise-control-not-working.html
Car will not run after resetting inertia switch on Mercury Mystique?
It sounds like a door is open or window is down on the rear passenger door of crew cab?
http://schematicsdiagram.blogspot.com/2011/12/it-sounds-like-door-is-open-or-window.html
VAN emits whitish bluish smoke and bad fuel smell from exhaust
Car stalls and throws white smoke from exhaust?
http://repairhelpcenter.blogspot.com/2012/01/car-stalls-and-throws-white-smoke-from.html
Car cigarette lighter fuse blows out?
Car will not start security lock out?
http://technoanswers.blogspot.com/2011/12/car-will-not-start-security-lock-out.html
Removal & Installation
- Raise and safely support the vehicle.
- Remove the front wheels.
- Remove the 2 caliper bolts and lift the caliper from the disc.
- Slide the disc pads off the caliper bracket.
To install:
- Clean the caliper bracket contact surface with a wire brush and lightly coat with assembly lube.
- Position the disc pads.
- Position the caliper over the disc assembly. Install the caliper bolts. Tighten to 72 ft. lbs. (98 Nm).
- Install the front wheels. Tighten the lug nuts 77 ft. lbs. (99 Nm).
- Bleed the hydraulic system if the flex hoses were removed.
- Lower the vehicle.
- Raise and safely support the vehicle.
- Remove the front wheels.
- Remove the 2 caliper bolts and lift the caliper from the disc.
- Slide the disc pads off the caliper bracket.
To install:
- Clean the caliper bracket contact surface with a wire brush and lightly coat with assembly lube.
- Position the disc pads.
- Position the caliper over the disc assembly. Install the caliper bolts. Tighten to 72 ft. lbs. (98 Nm).
- Install the front wheels. Tighten the lug nuts 77 ft. lbs. (99 Nm).
- Bleed the hydraulic system if the flex hoses were removed.
- Lower the vehicle.
- Before servicing the vehicle, refer to the Precautions Section.
- Raise and safely support the vehicle.
- Remove the front wheels.
- Remove the 2 caliper bolts and lift the caliper from the disc.
- Slide the disc pads off the caliper mounting bracket.
To install:
- Clean the caliper bracket contact surface with a wire brush and lightly coat with assembly lube.
- Position the disc pads.
- Position the caliper over the disc assembly. Install the caliper bolts. Tighten to 13 ft. lbs. (17 Nm).
- Install the front wheels. Tighten the lug nuts 77 ft. lbs. (99 Nm).
- Bleed the hydraulic system if the flex hoses were removed.
- Lower the vehicle.
This should help.
Thanks.
See below list of solved car problems :-----