The detailed procedure to perform this task i as follows :-----
REMOVAL AND INSTALLATION:-------
Bumper Cover — Front
NOTE: The fender clips are removed with the front fender. Use a flat-blade screwdriver to release the
locking tabs from the front bumper cover.
Removal and Installation
Explorer/Explorer Sport Trac:--
1. Remove the headlamp assemblies.
All vehicles
2. Disconnect the fog lamp electrical connectors, if equipped.
3. Disconnect the side turn signal lamp electrical connectors, if equipped.
4. Remove the front fender inner splash shield screws.
5. Remove the front fender inner splash shield pin type retainers.
6. Remove the front fender inner splash shields.
upward.
7. Remove the 2 bolts from the bottom of the bumper cover.
8. Remove the 6 grille-to-grille opening panel scrivets.
9. Release the bumper cover-to-fender clips.
10. Remove the bumper cover upper screws.
11. Rotate the bottom of the front bumper cover
12. Apply downward pressure to the top of the front bumper cover to release the 3 locking
tabs.
All vehicles
13. Remove the front bumper cover.
14. To install, reverse the removal procedure.
Also click this link for diagrams of this procedure:----
http://ww2.justanswer.com/uploads/fordguy4u/2012-01-26_225326_a2.pdf
This details will help.
Thanks.
See below latest solved car problems :--------
How to remove Intake Manifold Tuning Valve?
http://technoanswers.blogspot.com/2012/01/how-to-remove-intake-manifold-tuning.html
CMFI details for GMC vehicles?
http://technoanswers.blogspot.com/2012/01/cmfi-details-for-gmc-vehicles.html
Mazda MPV cranks but will not start?
MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?
http://technoanswers.blogspot.com/2012/01/mazda-mpv-will-crank-but-not-turn-over.html
Freightliner fl112 fuse box diagram?
http://technoanswers.blogspot.com/2012/01/freightliner-fl112-fuse-box-diagram.html
Car will not turn the ignition to start?
http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html
Car only starts when gas pedal is pressed?
http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html
Hyundai coupe f2 hazard fault?
http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html
Where is the bulb located in glove box?
http://repairhelpcenter.blogspot.com/2012/01/where-is-bulb-located-in-glove-box.html
Additional wiring harness needs to be installed in a brake controller for electric brakes on 2012
http://repairhelpcenter.blogspot.com/2012/01/additional-wiring-harness-needs-to-be.html
Fail smog test due to gas filter hose?
http://repairhelpcenter.blogspot.com/2012/01/fail-smog-test-due-to-gas-filter-hose.html
Clutch squeaking under hood?
http://repairhelpcenter.blogspot.com/2012/01/clutch-squeaking-under-hood.html
Replace door stay assemblies on
http://repairhelpcenter.blogspot.com/2012/01/replace-door-stay-assemblies-on-toyota.html
Acceleration lag problem?
http://repairhelpcenter.blogspot.com/2012/01/acceleration-lag-problem.html
How to Replace rear quarter glass on
http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-rear-quarter-glass-on.html
Overdrive light in the dash blinks?
http://repairhelpcenter.blogspot.com/2012/01/overdrive-light-in-dash-blinks.html
How to bypass immobiliser on Rover 200?
http://technoanswers.blogspot.com/2012/01/how-to-bypass-immobiliser-on-rover-200.html
Hood clear coat peeling off?
http://repairhelpcenter.blogspot.com/2012/01/hood-clear-coat-peeling-off.html
Engine stumbles coming off idle when warm?
http://repairhelpcenter.blogspot.com/2012/01/engine-stumbles-coming-off-idle-when.html
How to Refit Rear seat on Rover 600?
http://repairhelpcenter.blogspot.com/2012/01/how-to-refit-rear-seat-on-rover-600.html
How to replace the speakers on 2011 Ford Edge?
http://technoanswers.blogspot.com/2012/01/how-to-replace-speakers-on-2011-ford.html
How to Remove Rear seat on Rover 600?
http://repairhelpcenter.blogspot.com/2012/01/there-are-3-10mm-bolts-at-back-of-seats.html
http://technoanswers.blogspot.com/2012/01/toyota-solara-rattling-in-rear.html
Parking light stay on constantly?
http://repairhelpcenter.blogspot.com/2012/01/parking-light-stay-on-constantly.html
Engine hard to start after gas refill?
http://repairhelpcenter.blogspot.com/2012/01/engine-hard-to-start-after-gas-refill.html
How to replace wheel bearing on Honda Civic?
http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-wheel-bearing-on-honda.html
Do snow tires go on the back or front?
Where is Key chip memory located on 2004 ford Freestar?
How to fill Brake line antifreeze on freightliner classic?
http://technoanswers.blogspot.com/2012/01/how-to-fill-brake-line-antifreeze-on.html
Orange O/D warning light flashing on dash?
http://repairhelpcenter.blogspot.com/2012/01/orange-od-warning-light-flashing-on.html
GMC ENVOY spare tire system stopped working?
http://repairhelpcenter.blogspot.com/2012/01/gmc-envoy-spare-tire-system-stopped.html
Car starts and cuts off immediately?
http://repairhelpcenter.blogspot.com/2012/01/car-starts-and-cuts-off-immediately.html
Where is ECM located on 1997 Ford Ranger?
http://technoanswers.blogspot.com/2012/01/where-is-ecm-located-on-1997-ford.html
REMOVAL AND INSTALLATION:-------
Bumper Cover — Front
NOTE: The fender clips are removed with the front fender. Use a flat-blade screwdriver to release the
locking tabs from the front bumper cover.
Removal and Installation
Explorer/Explorer Sport Trac:--
1. Remove the headlamp assemblies.
All vehicles
2. Disconnect the fog lamp electrical connectors, if equipped.
3. Disconnect the side turn signal lamp electrical connectors, if equipped.
4. Remove the front fender inner splash shield screws.
5. Remove the front fender inner splash shield pin type retainers.
6. Remove the front fender inner splash shields.
upward.
7. Remove the 2 bolts from the bottom of the bumper cover.
8. Remove the 6 grille-to-grille opening panel scrivets.
9. Release the bumper cover-to-fender clips.
10. Remove the bumper cover upper screws.
11. Rotate the bottom of the front bumper cover
12. Apply downward pressure to the top of the front bumper cover to release the 3 locking
tabs.
All vehicles
13. Remove the front bumper cover.
14. To install, reverse the removal procedure.
Also click this link for diagrams of this procedure:----
http://ww2.justanswer.com/uploads/fordguy4u/2012-01-26_225326_a2.pdf
This details will help.
Thanks.
See below latest solved car problems :--------