Replacing blower motor is not very difficult.
The procedure is as follows :----
How to replace Blower Motor on Acura Car models?
http://repairhelpcenter.blogspot.com/2011/11/how-to-replace-blower-motor-on-acura.html
Heater/AC blower motor not working on 1995 Isuzu Trooper?
Heater problem on Isuzu Trooper?
http://technoanswers.blogspot.in/2012/02/heater-problem-on-isuzu-trooper.html
Blower fan not running on Isuzu trooper?
Heater makes clicking noise under dash on Ford Explorer?
http://technoanswers.blogspot.in/2012/01/heater-makes-clicking-noise-under-dash.html
Replace blower motor?
How to replace blower motor fan assembly on 2000 GMC
http://repairhelpcenter.blogspot.com/2012/01/how-to-replace-blower-motor-fan.html
Audi A4 blower motor blows Warm Air?
Heater stuck on defrost?
Where is Blower motor resistor located on 2006 Ford F 250?
http://schematicsdiagram.blogspot.com/2011/12/where-is-blower-motor-resistor-located.html
Dodge Caravan AC Heater Control only works on high mode?
Honda Civic Blower Motor Only works on high mode?
http://schematicsdiagram.blogspot.com/2011/12/honda-civic-blower-motor-only-works-on.html
How to Test and Replace Blower motor on car?
http://repairhelpcenter.blogspot.com/2011/12/how-to-test-and-replace-blower-motor-on.html
How to Replace Blower Motor Wheel?
How to Replace Blower Motor on 2008 Honda Odyssey?
How to Remove Blend Door Actuator on 2008 Honda Odyssey?
How to Remove Passenger Side Blend Door Actuator on 2008 Honda Odyssey?
How to Remove Driver side Blend Door Actuator on 2008 Honda Odyssey?
Blower motor Resistor shorting problem?
http://schematicsdiagram.blogspot.com/2011/12/blower-motor-resistor-shorting-problem.html
The procedure is as follows :----
- Disconnect the negative battery cable.
- Remove the lower right underpanel silencer duct.
- Disengage the blower motor wiring connector from the resistor block.
- On Sebring coupe and Avenger models equipped with a 2.0L engine and A/C, remove the automatic compressor ECM.
- Remove the blower motor mounting fasteners.
- Lower the blower motor assembly from the unit housing.
To install:
- Raise the blower motor into position in the unit housing and secure with the mounting fasteners.
- Attach the blower motor electrical connector.
- Install the automatic compressor ECM, if so equipped.
- Install the lower right underpanel silencer duct.
- Connect the negative battery cable.
This details will help.
Thanks.
See below blower motor related help,solutions:-----