@

Wednesday, February 8, 2012

Power Recirculating Ball Steering Gear removal on Chevy silverado 2500 HD?

The procedure to continue this task is as follows :----


  1. Raise and support the front end on jack stands.
  2. Remove as much power steering fluid from the reservoir as possible.
  3. Remove the engine under cover.
  4. On diesel models, remove the wheelhouse liner.
  5. Disconnect the hoses from the steering gear. Plug the lines to prevent leakage and contamination.
  6. Disconnect the steering shaft coupling from the gear.
  7. Remove the pitman arm nut, then separate the arm from the relay rod using puller J24319-B or equivalent.
  8. Remove the steering gear bolts and remove the gear from the vehicle.
To install:
  1. Install the gear in the vehicle. Tighten the bolts to 110 ft. lbs. (150 Nm).
  2. Connect the pitman arm to the relay rod.
  3. Connect the power steering hoses. Tighten the fittings to 24 ft. lbs. (32 Nm).
  4. The remaining installation is the reverse of removal. Bleed the power steering system. 

    Click image to see an enlarged view
    Fig. Exploded view of the power steering gear assembly-2007 models, except Classic




This will help.
Thanks.


See below latest solved car problems.



Steering Wheel Locked?


How to replace Power Rack and Pinion Steering Gear on Acura Car Models?


How to replace Power Steering Pump on Acura Car Models?

Also bleeding:
                                    

How to replace Steering Linkage on Acura Car Models?


How to replace Steering Wheel on Acura Car Models?

How to replace Power Steering Pump on 1999 Acura TL?

How to Disarming the Air Bag System?

http://technoanswers.blogspot.com/2011/12/how-to-disarming-air-bag-system.html


@