How to replace blower motor and blower motor resistor on Pontiac G6?

Its simple.
The procedure is as follows :---

1. Remove the right closeout panel.
2. Remove the blower motor wire harness connector.
   
   NOTE

   Cut through the case as straight as possible because the motor cup must be replaced. In order to prevent damage to the component, do not cut any deeper than necessary to remove the motor cup.
3. Cut out the blower motor using a utility knife in the narrow groove of the lower case.
4. Remove the blower motor.
5. Remove the blower motor nuts.
6. Remove the blower motor from the blower motor cup.

To install:

1. Install the new blower motor to the blower motor cup.
2. Install the blower motor nuts and tighten to 21 inch. lbs. (2.4 Nm).
3. Install the motor blower seal to the blower motor service ring.
4. Install the blower motor.
5. Install the blower motor attachment ring.
6. Install the blower motor screws.
7. Install the blower motor wire harness connector.
8. Install the right closeout panel.

1. Remove the right closeout panel.
2. Remove the blower motor resistor wire harness connector.
3. Remove the blower motor resistor screws.
4. Remove the blower motor resistor. 
   
   
   

   Fig. Blower motor resistor view

To install:

1. Install the blower motor resistor.
2. Tighten the blower motor resistor screws and tighten to 13 inch. lbs. ( 1.5 Nm).
3. Install the blower motor resistor wire harness connector.
4. Install the right closeout panel.

This will help.Thanks.

See below latest solved car problem.

Blower motor replacing for all vehicles?

http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html