Sunday, June 26, 2011

how to replace thermostat on Acura 3.2TL ?

  • The thermostat in Acura TL is under the hood, on the passenger side of the vehicle. It is located inside the "thermostat housing," which is positioned between the upper radiator hose and the engine. You can find the housing by following the upper radiator hose to where it meets the engine.


  • Open the engine compartment of the Acura 3.2TL and prop the hood with the prop rod. Use a wrench to loosen the nut on the battery terminal and disconnect the negative cable from the battery to prevent accidentally shorting any of the electrical parts on the car.

  • Open the valve on the bottom of the radiator and drain the engine coolant into a drain pan. Remove the upper radiator hose from the thermostat housing using a screwdriver to loosen the hose clamp.

  • Loosen the bolts on the thermostat housing using a wrench and remove the housing from the engine. Remove the thermostat from the engine and discard it. Note the way the thermostat is situated on the engine as the new one will have to go in the same way.

  • Remove the old gasket material using the scraper to remove any gasket material stuck on the engine and thermostat housing. Place a new thermostat in the engine. Install a new gasket and replace the thermostat housing. Tighten the thermostat housing bolts using a wrench.

  • Connect the upper radiator hose to the thermostat housing and tighten the hose clamp with a screwdriver. Refill the radiator and reservoir with engine coolant. Connect the negative cable to the battery and tighten the terminal nut using a wrench. Start the Acura 3.2TL and allow the engine to reach operating temperature to be sure it does not overheat.


    To Order car parts online:--To get heavy discount on car parts .Click this link below:----


    For car error code diagnosis click the link below:---



  • @