(2) Remove engine cover ..
NOTE: Press in on fuel line locking tab to release
fuel line. Pull back on locking tab to return to lock
position.
(3) Remove fuel return flow line to high pressure
pump.
(4) Disconnect glow plug electrical connector .
WARNING: RISK OF INJURY TO SKIN AND EYES
FROM HANDLING HOT OR GLOWING OBJECTS.
WEAR PROTECTIVE GLOVES, CLOTHING AND EYE
WEAR.
(5) Remove glow plugs and clean glow plug bay
---------------
Click this link for glow plug location and picture:--
------------
Open the hood of your jeep and locate the negative battery cable on the top of the battery. The battery sits on the driver's side of the engine compartment, right behind the driver's-side headlight assembly. Loosen the clamp bolt on the cable end with a wrench and remove the cable from the battery, isolating it from the terminals while you are working.Locate the glow plug in question on the side of the cylinder head. The cylinder head is at the top of the engine assembly, running front to back along the engine block. Grasp the wire at the top of the glow plug at the boot and pull it straight off the plug. Lay the wire aside.Place a socket over the glow plug, attach a ratchet, and turn the plug counterclockwise. Pull the plug out of the cylinder and discard it.Carefully insert the new glow plug in the cylinder head. Tighten the glow plug to 110 inch-pounds with a torque wrench. Snap the wiring harness connector onto the top of the glow plug. Repeat the process for the remaining glow plugs until you have replaced all that are defective.Install the negative battery cable on the negative battery terminal. Tighten the clamp bolt with a wrench, making sure it is secure. Do not over-tighten it or you may damage the cable end or terminal. Close the hood of your Jeep.
--------------
How to troubleshoot vehicle that is not starting?
http://technoanswers.blogspot.com/2011/06/how-to-troubleshoot-ford-escort-that-is.html
