Timing Belt
Removal & Installation
2.0L (VIN P) Engines
- Remove or disconnect the following:
Negative battery cableAccessory drive belt and tensionerTiming belt coverRight front wheelRight inner splash shieldCrankshaft pulley - Align the timing marks as shown.
- Refer to the illustration and remove the timing belt as follows:
To install:
- Install the timing belt in a counterclockwise direction starting at the crankshaft.
- Remove the drill bit to unlock the timing belt tensioner.
- Rotate the crankshaft two complete turns and check that the timing marks align.
- Tighten the tensioner bolt to 15-22 ft. lbs. (20-30 Nm).
- Install or connect the following:
Crankshaft pulley. Tighten the bolt to 81-96 ft. lbs. (110-130 Nm).Right inner splash shieldRight front wheelTiming belt coverAccessory drive belt and tensionerNegative battery cable - Start the engine and check for proper operation.
-----------
For more car related problem troubleshooting:---
This are the sections, you can go through and click the link to read its troubleshooting.
---------
The car will not start?
-----------------
Car will not crank?
-----------
Car has no spark?
-------------
How to troubleshoot car battery?
-----------------
How to test starter solenoid?
http://schematicsdiagram.blogspot.com/2011/06/how-to-test-starter-solenoid.html
--------------------
How to test cars starter?
http://schematicsdiagram.blogspot.com/2011/06/how-to-test-cars-starter.html
How to replace starter in car?
-----------
car will turn over but will not start?
-----------------