@

Monday, March 5, 2012

Throttle Body Removal For Acura Car?

Please Note This details and procedure are For Acura 1986 to 1993 car models.
Its For Acura Integra,Legend and Vigor car models.

The details are as follows :-----

Throttle Body
REMOVAL & INSTALLATION

REMOVAL & INSTALLATION



See Figures 1, 2 and 3
  1. Disconnect the air intake tube from the throttle body.
  2. Drain the cooling system, at least to a level below the throttle body.
  3. Disconnect the coolant hoses running to the throttle body.
  4. Label and disconnect the vacuum hoses from the throttle body.
  5. Disconnect the wiring connector(s) from the throttle body.
  6. Label and disconnect the throttle control, cruise control and/or accelerator cable. Do not kink the cables.
  7. Remove the nuts holding the throttle body to the intake chamber or plenum. Loosen each nut 1-2 turns at a time to release the pressure evenly.


image
Fig. Fig. 1: Throttle body assembly-Integra


Click image to see an enlarged view
Fig. Fig. 2: Throttle body assembly-Legend


Click image to see an enlarged view
Fig. Fig. 3: Throttle body assembly-Vigor
  1. Remove the throttle body assembly. Remove and discard the gasket. Some models use a solid insulator below the throttle body instead of a regular gasket. This base may be removed after its retaining bolts are removed. If the insulator is in good condition and free of any cracks or distortion, it may be reused.
To install:
  1. Install a new gasket or insulator on the plenum. If an insulator is in use, tighten its retaining bolts to 16 ft. lbs. (22 Nm). Install the throttle body onto the studs.
The gasket or insulator is correctly installed in only one position; make sure the grooves and passages in the gasket align with the matching openings on the air chamber.
  1. Install the retaining nuts. Tighten them evenly and alternately to 16 ft. lbs. (22 Nm).
  2. Install the cruise control, throttle control and/or accelerator cables.
  3. Connect the vacuum hoses.
  4. Connect the coolant hoses.
  5. Refill the cooling system.
  6. Connect the air intake ducts.


This details will help.
Thanks.

For more help,go to 


@