The procedure to replace Toyota Sienna Steering wheel.
The details and diagrams to remove and install steering wheel.
All is mentioned here as follows:---
Car repair guide?
http://technoanswers.blogspot.in/2012/03/car-repair-guide.html
The details and diagrams to remove and install steering wheel.
All is mentioned here as follows:---
These models are equipped with a Supplemental Restraint System (SRS), which uses an air bag. Whenever working near any of the SRS components, such as the impact sensors, the air bag module, steering column and instrument panel, disable the SRS.
- Before servicing the vehicle, refer to the precautions section.
- Disconnect the negative battery cable and wait AT LEAST 90 seconds before beginning the procedure.
- Align the front wheels straight ahead position.
NOTEUnplugging the air bag connector with the ignition switch in the On or ACC position will result in a DTC being recorded. - Using a Torx® socket, loosen the 2 Torx® screws until the groove along the screw catches on the screw case.
- Pull the wheel pad from the steering wheel and disconnect the airbag connector. Store the wheel pad with the upper surface facing upwards. Do not disassemble the wheel pad.
NOTEBe careful not to pull on the air bag wiring harness when removing the wheel pad.
- Disconnect the electrical connector.
- Remove the steering wheel nut.
- Make match marks on the steering wheel and shaft.
- Install a suitable puller and remove the steering wheel.
These details will help.
Thanks.
FOR MORE HELP GO TO: ---