Monday, March 5, 2012

How to replace Fuel System Igniter on Acura Car Models?

Please Note This details and procedure are For Acura 1986 to 1993 car models.
Its For Acura Integra,Legend and Vigor car models.

The details are as follows :-----



Remove the distributor from the engine.
Remove the cap, rotor and seal.
Remove the protective cover under the cap
Remove the protective cover from the ignition coil and remove the coil.
Remove the retaining screws and remove the igniter from the distributor housing.

See Figure 1

Fig. Fig. 1: Igniter unit mounting-Integra
To install:
  1. Install the igniter and tighten the retaining screws.
  2. Install the coil and coil cover.
  3. Reassemble the leak cover, rotor, seal and distributor cap.
  4. Install the distributor.
Except Integra
The igniter is mounted externally in the engine compartment. For 1986-1990 Legend, it is on the left shock tower; on 1991-93 Legends, it is on the right front shock tower, just behind the underhood fuse/relay box. For 5 cylinder Vigor engines, the igniter is on the right fender apron, near the firewall. To remove these igniters, turn the ignition switch OFF , disconnect the connector and remove the retaining bolts. Reinstall in reverse order.

This details will help.

For more help,go to

Car repair guide?