To replace the bulbs or light lens, the outer mirror cover must be removed first.
Adjust the passenger side mirror using the power control on the driver's door so that it is moved all the way to its outward-most adjustment, creating a gap on the inboard side closest to the side. Use a flashlight and peer into the mirror housing behind the gap and locate one of the three retaining clips that attach the mirror housing's outer plastic cover. Insert a long flat blade screwdriver into the gap and depress the release tab on the retaining clip.
Adjust the mirror downward to its lowest setting, which should create a gap at the top between the mirror and the housing. Locate the second retaining clip through this gap and release it in the same manner.
Adjust the mirror to its uppermost setting, which should create a gap at the bottom between the mirror and the housing. Locate the third clip through this gap and release it in the same manner. Pull the outer plastic cover from the mirror housing and place it aside.
Locate the mirror light's wiring harness and pull it apart. Pull the light assembly from the housing and remove it from the vehicle. Press in on the two release clips on the light lens to remove it from the light assembly. Push a new lens in position until it snaps into place.
Push the light assembly back into place in the mirror housing. Plug the light's wiring harness back together until it is fully seated. Push the outer plastic mirror housing cover into position until it snaps into place.
---------------------
Protect edge of housing - 1 - from damage to paintwork e.g. with fabric-reinforced adhesive tape.
- Press bottom of mirror glass into mirror housing.
- Press off - arrow5 - mirror glass - 3 - from retainer - 2 - , using pry lever 80-200.
- Fold mirror glass upward - arrow 6 - and disconnect connector - 4 - for mirror heater on back of mirror glass.
Removing Mirror housing, removing and installing
- Remove mirror glass (see post above)
- Fold rearview mirror toward front for easier assembly.
- Remove four bolts - 1 - .
- Loosen bolt - 3 - and remove with cap - 2 - .
- Pull off mirror housing - 5 - upward from mirror base plate - 4 - .
Removing Entry Light
- Remove mirror glass (see above)
- Removing - Remove mirror housing (see above)
- Disengage and disconnect connection - 1 - on backside of mirror base plate - 2 - .
- Carefully press entry light - 2 - by hand out of locking tabs in assembly component - 1 - .
Side turn signals, removing and installing
Removing - Remove mirror glass (see above)
Removing - Remove mirror housing (see above)
Removing - Remove entry light (see above)
- Disengage and disconnect connection - 1 - and - 3 - on backside of mirror base plate - 2 - .
- Remove bolts - 1 - (Qty. 2) on front of mirror base plate.
- Remove assembly component - 2 - downward - arrow - from mirror base plate.
- Remove two bolts - 1 - and remove assembly component - 2 - from side turn signal - 3 - .
Also click this link to see the video of near to same job:---
http://www.youtube.com/watch?v=RoK0USRf9xk&feature=player_embedded
-----------------
