Programming Remote:---
Turn off your vehicle and insert your remote in the remote transmitter pocket located in the center console with the buttons facing the front.
Put your key in the door lock and rotate the key to the "Unlock" position five times in five seconds. Look at your DIC and it will display "OFF/ACC TO LEARN".
Press the "ACC" button on your ignition switch. Your DIC will prompt you to wait ten minutes, after which the DIC will read "OFF/ACC TO LEARN". Press the "ACC" button on your ignition switch again. Repeat this process three times.
Listen for a beep; when you hear the beep the DIC will read, "FOB Ready for #2". Remove your remote from the transmitter pocket and press the "Unlock" button twice to complete programming and insert a new remote.
Remote Key FOB Information
Transmitter Programming
1. Close all the vehicle doors.
2. Insert the ignition key into the ignition lock cylinder.
3. Press and hold the door unlock switch.
4. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
5. Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
6. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to 4 transmitters.
8. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter programming mode.
Transmitter Programming
1. Close all the vehicle doors.
2. Insert the ignition key into the ignition lock cylinder.
3. Press and hold the door unlock switch.
4. While holding the door lock switch in the unlock position, cycle the ignition ON, OFF, ON, OFF.
5. Release the door unlock switch. The doors will lock and unlock to confirm the program mode.
6. Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. After a delay of approximately 15 seconds, the doors will lock and unlock to confirm the programming of that transmitter.
7. Repeat the previous step to program up to 4 transmitters.
8. Turn the ignition switch to the RUN position in order to exit the keyless entry transmitter programming mode.
