@

Sunday, March 31, 2013

Jeep grand cherokee 0 oil pressure

Oil Pressure Shows Zero On Gauges


Check gauges light. 0 oil pressure on gauge. No big oil leak, good oil level. cycled ignition few more times, then gauge starts to move. Goes up to 80 (max line) and stays there.


Vehicle Details:

Make (manufacturer): jeep
Model: grand Cherokee 6cyl 2001 Laredo
Year: 2001


Expert's Reply:

Is It Faulty Gauge Or Its Oil Pressure Problem?


You've got a gauge issue rather than an actual oil pressure problem. Even if the pressure was truly at 80 when cold and accelerating, when the engine warms and especially at idle the pressure should drop much lower, to the lower end of the scale on the gauge. If the oil is full and you aren't hearing any abnormal noises from the engine then it clears that  actual oil pressure is ok.


Then What's The Actual Problem?

What you are experiencing are common symptoms of a failed oil pressure sending unit on a 4.0 engine. The oil sender threads into the right side of the engine block in the rear and receives pressurized oil from the engine, interprets that into an electrical signal and sends the information to the powertrain control module. It then sends that to the instrument cluster for gauge operation.


Is It Common Problem On These Model Vehicles?

When the sender on a 4.0 fails it usually does so in the way you have described, oil pressure will show about 80 PSI all the time no matter what. I believe you would find that if you turned the key on without even starting the engine it would still show the 80 PSI. If so then you could unplug the sender and see if the gauge drops. If so then you know the wiring is good and the sender itself is the problem.


Ok,How To Replace Oil Sender Unit?


Replacing it just involves unplugging the connector and threading the old one out of the engine block. It's best removed with a socket but you may be able to grab onto it with some good adjustable pliers.
For your information the original sender have a hex for a large socket (It is some what 1 3/16") and the replacement sender will likely have a standard oil sender hex which requires a special oil sender socket like the one shown here:

jeep Cherokee oil sender

The exact design of the replacement will depend on what brand it is and where you purchase it from. Again you might be able to use adjustable pliers if you have some that are large enough and will grip it tightly, but it is easiest to use a socket.




ALSO VIEW THIS RELATED:

For Car parts and diagrams:

CAR MANUAL GUIDE
                 
FOR FREE MANUALS AND GUIDES: ---
Car repair guide?


For all types of car repair help:



Car Backfires

For car repair How to guides:


OVERHEATING: Radiator Fan Not Working

Engine Cooling Fan not Working


"Radiator fan"  "Engine Fan"  "COOLING FAN WILL NOT TURN OFF"

LIFT GATE / TAIL GATE ISSUES

TRUNK WILL NOT OPEN


CAR ALARM ISSUES


Car starter removal, Starter motor testing, Starter repairs, Starter solenoid, Starter wiring,


DOOR PANEL REMOVAL, car door panel, door panel components, front door panel, rear door panel,


HEATER CORE REPLACEMENT, HEATER CORE REMOVAL, TROUBLESHOOT HEATER CORE, FLUSH HEATER CORE,

CAR POWER SEAT, ELECTRIC SEAT, POWER SEAT WILL NOT WORK, SEAT WILL NOT GO FORWARD,



For all types of---------

Timing belt routing diagrams for cars and trucks?



                          

==========

For all types of --------

Drive belt routing diagrams for cars and trucks?




stalling issues:
Engine stalls, car stalls while starting, vehicle stalls while starting, Engine stalls and dies, Car stalls and stops,


CRUISE CONTROL Not working, cruise control replacing, troubleshooting cruise control problems,


TRANSMISSION PROBLEMS:

NO REVERSE ON TRANSMISSION

GEAR SHIFT ISSUES

Transmission fluid leak, transmission gears slip,


TRANSMISSION REPLACING AND TROUBLESHOOTING, INSPECTING TRANSMISSION COMPONENTS, TRANSMISSION FAILURES, OD WARNING LIGHT,


TRANSMISSION FLUID FILLING, WHERE TO FILL TRANSMISSION FLUID, AUTOMATIC TRANSMISSION FLUID, NO TRANSMISSION DIPSTICK,


WINDSHIELD WIPERS, WINDSHIELD WIPERS NOT WORKING,WIPER MOTOR MAKING NOISE,NO WIPERS,WIPER FLUID LEAKS,WIPER FUSE AND RELAY,


COOLANT LEAK ISSUES, COOLANT LEAK PROBLEMS, COOLANT SENSOR, LOW COOLANT,


BRAKE LIGHTS NOT WORKING, REPAIRING BRAKE LIGHTS, NO BRAKE LIGHTS,


CHECK ENGINE LIGHT,ENGINE WARNING LIGHT FLASHING,ENGINE LIGHT ON DASH,DASHBOARD WARNING LIGHT,ECM ERROR CODES,


DASHBOARD WARNING LIGHTS ARE ON, ENGINE LIGHT ON DASH,WARNING LIGHTS STEADY ON DASH,RESET DASH BOARD WARNING INDICATOR,


KEYFOB PROGRAMMING, REPROGRAMMING CAR KEY, KEYLESS ENTRY RESET,ANTITHEFT WILL NOT LET CAR TO START, ANTI THEFT ISSUES, KEYFOB NOT WORKING, KEYLESS ENTRY QUIT WORKING,


IGNITION KEY WILL NOT RELEASE, IGNITION KEY STUCK UP, KEY WILL NOT COME OUT OF IGNITION, FAULTY IGNITION KEY LOCK CYLINDER, REPLACING IGNITION CYLINDER,


HEATER ISSUES:

HEATER NOT BLOWING COLD,NO HOT AIR FROM HEATER,A/C BLOWS HOT AIR,A/C NOT BLOWING COLD, COLD AIR FROM HEATER,BLEND DOOR ACUTATOR CLOSED,HVAC UNIT NOT OPERATING,



HEATER NOT BLOWING COLD,NO HOT AIR FROM HEATER,A/C BLOWS HOT AIR,A/C NOT BLOWING COLD, COLD AIR FROM HEATER,BLEND DOOR ACUTATOR CLOSED,HVAC UNIT NOT OPERATING,



STEERING ISSUES:

POWER STEERING TROUBLESHOOTING, STEERING SQUEAKS, POWER STEERING FLUID LEAKS, FAULTY POWER STEERING PUMP, POWER STEERING NOT WORKING, POWER STEERING BELT,



VEHICLE STARTING ISSUE:

CAR NO START: ENGINE NOT TURNING OVER:


@