Sit behind the dome light assembly. Pry the rear of the light assembly down with a flat-bladed screwdriver until the retaining clips release.Slide the front of the light assembly out of place, using caution not to break the tabs in the front.Remove the three small Torx screws securing the bulb with a Torx screwdriver. Pull the bulb out of the socket. Push the new bulb into place until it is all the way in the socket. Replace the Torx screws and tighten them with the Torx screwdriver.Align the front of the cover in position, then push the back of the light cover up into place. The clips will click when they are secure.
----------------
The Dome Light replacing on Chevy Impala:----------
Sit in the driver's seat of your Chevrolet Impala. The dome light will either be located in the center of the car's roof interior, or towards the front of the roof interior as part of an overhead storage bin. The location will depend on the year of your Impala.Remove the light cover. Some older models will have the light cover attached to the light frame with two screws. Use a Phillips head screwdriver to remove the screws and place them to the side where you can find them again. If you have a later model Chevrolet Impala, the light cover is held in place by spring clips in the frame. Reach up and grasp the plastic of the cover and squeeze it slightly while pulling the cover down. The spring clips will release and the cover will open like a door on a hinge.Pinch the existing bulb between your thumb and forefinger firmly enough that you are holding the glass of the bulb but not enough to risk breaking it. Push the bulb in, turn it counter clockwise and pull it free from the socket.Install the new bulb by pushing the bulb into the socket. You will be able to see a channel in the socket that you need to line up with the small raised plug on the side of the bulb end. Turn the bulb clockwise. Pull gently on the bulb to make sure that it is locked into the socket. Close the light cover by pressing it into place and either squeezing the sides while pushing it up to lock it into the spring clips, or put the retaining screws back in.Consult your owner's manual to locate your fuse box and the location of the fuse for your dome lights. Remove the fuse by pinching the fuse and pulling out of the fuse holder. Look at the center of the fuse and you will see a metal wire in the center connecting the two ends. If this wire is broken or black, replace the fuse. If the wire is complete, reinstall the fuse by pushing it back into position.
---------------------
How to replace dome light on 2001 Chevrolet Tracker:----------
This is from a 2001 Chevrolet Tracker owners Manual
Dome Lamp
1. Gently pry the dome lamp lens from the lamp
assembly using a screwdriver.
2. Remove the bulb by gently opening the retaining clip
and sliding the bulb out.
3. Insert a new bulb. Make sure that it is
seated properly.
4. Snap the dome lamp lens back into the dome
lamp assembly.
Where is the Dome Lamp Switch on a 2009 Chevy HHR?
The controls for the dome lamp is located to the right of the steering wheel and above the radio. It is the same control for your dash lighting. If you turn it all the way to the right it has 3 selections. Off, Door, and On are the selections. Off turns the dome lamp off, door turns the dome lamp on when any door is open and on turns the dome lamp on.-----------------
How to Replace the Dome Lights in a Chevy Silverado:------
the procedures are near to same , but not exact same in all Chevy models.but this will mostly help you to do the job.---------
