To Remove:
| Headlight locking ring removal 
|
NOTE: Remove the relay box for access to the left headlight bulb.
- Turn the locking cap counterclockwise and remove it.
- Remove the headlight bulb with socket.
To Install:
- Install the headlight bulb with socket.
- Turn the locking cap clockwise to lock it.
- Install the relay box if removed.
To Remove:
| Headlight assembly removal (1 of 2) 
|
| Headlight assembly removal (2 of 2) 
|
- Remove the bolts and clips from the bumper, splash shield and under cover as shown.
- Disconnect the connector from the fog light.
- Move the front bumper slightly and remove the headlight assembly (1).
To Install:
- Move the front bumper slightly and install the headlight assembly (1).
- Connect the connector to the fog light.
- Install the bolts and clips from the bumper, splash shield and under cover as shown
When adjusted properly, the lights should not glare in oncoming traffic's windshields, nor should they illuminate the passenger compartment of vehicles driving in front of you.
CAUTION
When headlights are replaced or any time front-end work is performed on the vehicle, the headlights should be aimed using the proper equipment. Headlights not properly aimed can make it virtually impossible to see and may blind other drivers on the road, causing injury or death.
- Park the vehicle on a level-surface, with the fuel tank about 1/2 full and with the vehicle empty of all extra cargo (unless normally carried)
- The vehicle should be facing a wall that is no less than six feet (1.8m) high and 12 feet (3.7m) wide
- The front of the vehicle should be about 25 feet from the wall
- If aiming is to be performed outdoors, wait until dusk to properly see the headlight beams on the wall
- If done in a garage, darken the area around the wall as much as possible by closing shades or hanging cloth over windows
- Turn the headlights ON.
- Mark the wall at the center of each light's low beam.
- Turn on the high beams and mark the center of each headlight's high beam.
- A short length of masking tape that is visible from the front of the vehicle may be used.
NOTE: Although marking all four positions is advisable, marking one position from each light should be sufficient.
| Low-beam headlight pattern alignment 
|
| High-beam headlight pattern alignment 
|
- Perform the necessary repairs.
- Turn the headlights ON.
- Adjust the beams to match the marks on the wall.
| High mounted brake light removal/installation 
|
License Plate Lights| License plate lights removal/installation 
|
| Taillight assembly removal/installation 
|
- Fog Light
