@

@

Saturday, December 10, 2011

Buick Lesabre Key Fob Reprogramming?

Key fob Programming is possible.But in some cases the programming dont work.This is due to two reasons.
Either you have not tried the procedure correctly or on your car the manual Key Fob Programming is not supporting.In that case I'm afraid its job for a dealership or a auto locksmith as you need someone with the OBD tools to plug into the car and re-code the key.Also all the keys have to be re-coded at the same time otherwise you'll get the new out of sync with the old.

Now the Key Fob Programming procedure is as follows :----------
First check that the battery in the key-fob is in good condition ( typically needs replacing every 5 years or so).
To do this Reprogramming procedure you will nee the OBD Scan Tool.
The scan tool is a diagnostic tool that automotive technicians use to diagnose & repair the computer systems of your automobile.

The details are as follows :----

Remote Control Door Lock Transmitter Programming:--
Important: 
  • All transmitters which are to be recognized by the remote control door lock receiver (RCDLR) must be programmed in a single programming sequence. 
  • If the system is placed in program mode, all previously programmed transmitters will be erased upon the receipt of the programming signal from the first transmitter. 
  • Up to four transmitters may be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry program mode. 
  • This prevents the programming of the transmitters to the incorrect vehicle. The order in which the transmitters are programmed is important. 
  • The first transmitter programmed will be transmitter #1, and the second transmitter programmed will be transmitter #2. 
  • The number on the transmitters are for reference only: #2 can be programmed as #1, or vice versa. Additional unnumbered transmitters are also available. Use care to program the transmitters correctly.
Now to Program Key Fob: Install a scan tool.
1) Turn ON the ignition, with the engine OFF.
2) Use the scan tool Remote Function Actuation Special Function: 
  • Program Key Fobs in order to place the remote control door lock receiver into Program Mode. 
  • The doors will lock and then unlock in order to confirm program mode.
Important: 
  • The scan tool must stay connected until all of the transmitters are programmed.

3) Press and hold the LOCK button and the UNLOCK button simultaneously on one transmitter. 
4) After a delay of 15 seconds, the doors will lock and unlock in order to confirm the programming of that transmitter.
5) Repeat the previous step in order to program up to 4 transmitters.
6) Remove the scan tool.
Operate the transmitter functions in order to verify correct system operation is working correctly.

But in some cases this procedure don't work and needs reset by dealer scan tool.Or in case if you don't have OBD scan tool.Then you have to either get a rent scan tool from auto parts store or get this procedure done by your car dealer.

This basic details will help.Thanks.
------------------
If you need dis-assembly or replacement instructions for any other auto/car part, or you want to ask question related to your car/truck jeep problem then please leave the comment with your details, so I can provide you the required instructions and solutions.


For related solutions,see the list below:---

After getting car washed, check engine light is ON and key less entry not working, tried reprogramming. Also car shows fuel pressure?

http://schematicsdiagram.blogspot.com/2011/12/after-getting-car-washedcheck-engine.html





Labels: buick cr key reprogram, car key reprogramming, car remote transmitter programming, key fobs, key less entry, keyfob reprogram, remote programming, steps to program car key

@

@