2002 Toyota Sienna: Wipers and Passenger side Power window stopped working?

Wipers started a bit then stopped working and Passenger side window stopped working at same time.
But all other windows work properly.

This types of problem many a times makes the car owner to think,that problem is same for both the faults.
But its not the same.

It can be faulty fuse or issue with Motor.
To remove the fuse out needle nose are fine. The fuse holder is under the hood fuse box.
The pivot on the wiper motor for the rear is known to freeze. There is also a circuit breaker built into the rear motor that can get burned. Pull the motor and check the shaft. The 25 amp wiper fuse is the only fuse for the rear wiper.
The front window is not related to wiper not operating.The windows work off of the 30 amp power fuse and feeds all the windows not just the right front window. If the other windows work it is not a fuse issue and more then likely is a bad window motor. The fuse box has a lock tab to depress and the lid pops off.

So for both the cases the issue is most probably the faulty motor.The Wiper operating motor and power window motor.

Getting this parts checked and inspecting before directly replacing will help.
Thanks.

For All types of Car models and brands help

Go to Newly Launched

FREE Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html

&

Complete Car repair Help FREE?

http://repairhelpcenter.blogspot.in/2012/03/complete-car-repair-help.html

2006 Toyota Sienna: How to replace Rear Spark Plugs?

Replacing spark plugs on toyota sienna.The Rear Spark plugs are behind the Intake plenum.Getting hands there is bit difficult.
You have two options here. The first one is to just remove the throttle body from the plastic intake manifold. This will give you a little more access to reach in and under the intake manifold itself. It still is tight but can be done. In order to remove the intake manifold to replace the spark plugs the wiper motor panel assembly and upper cowling has to be removed before the intake manifold will come off.
The plastic manifold itself has three brackets on the backside by the firewall which are very tight tolerances to unbolt then you have the obvious bolts along the top of the manifold that hold the manifold to the lower aluminum housing.

The throttle body comes off in two sections the first one is held on by either three or 4 -10 mm bolts then the second section is held on with about four to five 12 mm bolts. Given the age typically these rubber gaskets can be reused. The intake manifold is slightly different but basically the same when it comes to the throttle body configuration depending on whether you have the 3.3 L or the 3.5 L engine. In 2006 depending on your production you could have either engine.

This details will help.
Thanks.

For All types of Car models and brands help

Go to Newly Launched

FREE Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html

&

Complete Car repair Help FREE?

http://repairhelpcenter.blogspot.in/2012/03/complete-car-repair-help.html