@

Showing posts with label engine light. Show all posts
Showing posts with label engine light. Show all posts

Tuesday, April 2, 2013

Why Check Engine Light Comes ON?

Check Engine Light Comes On


2001 Jeep Cherokee Check Engine Light



There are dozens of things that can turn the engine light on but if you have the Jeep near I can tell you how to read the fault codes yourself.
If we can find out what codes are stored then I can give you a much more precise idea of what is going on. There is an easy built in code read feature we can use if you're able to get to the Jeep.


HOW TO RETRIEVE THE CODES MANUALLY WITHOUT A SCAN TOOL

The Procedure Is As Follows:
Cycle the key from off to on three times ending with it on and watch the digital odometer display. Don't crank the starter, just off to on. After the last time you turn the key on the fault codes will show up in the odometer display. The codes start with a P and have four numbers, there may be more than one stored.

Get in and close the doors, put the key in and turn it one click forward. This is the off position. One click forward of that is on. Start with it off and go on, off, on, off, on within about five seconds and the odometer will change and show codes. Remember to not crank the starter, just off to on.


REASONS FOR CHECK ENGINE LIGHT ON DASHBOARD:

Issue With Computer Module


  • There are dozens of things that can cause the check engine light to come on. The light comes on because the powertrain control module (PCM) sees a problem in a monitored system or component and sets a fault code. Any sensor on the engine, transmission issues, evaporation emissions, etc will all turn the light on.


You can check the air filter if you're questioning it, but the filter won't turn the light on.

Issue With Spark Plugs

  • The spark plugs were due for replacement at 30,000 miles so if they haven't been done then a tune up is in order. That may or may not be the reason the engine light is on though. 



Transmission Gear Shift Or Solenoid Issues


  • If you aren't noticing any symptoms the you can likely rule out anything transmission related. Most problems with the trans that would cause the light to come on would also cause shift problems.


Loose Gas Cap Or Emission Issues

  • Check your gas cap to make sure it's tight. The evaporative emissions system is checked for leaks, if your cap is loose or isn't sealing correctly it will turn the light on.


Evap Leak issues

  • It could also be a leak somewhere in the system. There are vapor lines from the engine back to the fuel tank, there could be a leak in a line, the canister, or there could be a problem with the leak detection pump or purge solenoid. Evap leaks are a very common reason for the engine light to be on with no symptoms.

Faulty Or Loose Or May Be Dirty Sensors

  • Any of the sensors on the engine could turn the light on. The up or downstream oxygen sensors, throttle position sensor, MAP sensor, coolant sensor, and intake air temperature sensor could all set a code either from a failed sensor or wiring issue. Sometimes you will have symptoms and sometimes not.

Cats Converter Issue

  • Catalytic converter efficiency is monitored, if one of them wasn't passing the monitor then it would turn the light on with no symptoms.


Issue With Oxygen (O2) Sensor

  • A failed oxygen sensor will often turn the light on with no symptoms also.



Faulty Ignition Coil Issue

  • The ignition coil can cause the light to come on as well as spark plugs or fuel injectors, but these will usually cause some rough running.


Crankshaft Or Camshaft Sensor Issue

  • The camshaft or crankshaft position sensor can cause the light, but usually these would also cause some driveability problems.


Faulty Thermostat issue

  • Once in a while thermostats on the 4.0 will fail and cause excessive warm up times and this will also set a code but you wouldn't notice anything except for it taking a while longer to warm up from a cold start, or the temperature gauge not getting into the normal range.

This are the most common possibilities,that can cause check engine light to come up on dashboard.

This will help.
Thanks.


ALSO VIEW THIS RELATED:

For Car parts and diagrams:

CAR MANUAL GUIDE
                 
FOR FREE MANUALS AND GUIDES: ---
Car repair guide?


For all types of car repair help:



Car Backfires

For car repair How to guides:


OVERHEATING: Radiator Fan Not Working

Engine Cooling Fan not Working


"Radiator fan"  "Engine Fan"  "COOLING FAN WILL NOT TURN OFF"

LIFT GATE / TAIL GATE ISSUES

TRUNK WILL NOT OPEN


CAR ALARM ISSUES


Car starter removal, Starter motor testing, Starter repairs, Starter solenoid, Starter wiring,


DOOR PANEL REMOVAL, car door panel, door panel components, front door panel, rear door panel,


HEATER CORE REPLACEMENT, HEATER CORE REMOVAL, TROUBLESHOOT HEATER CORE, FLUSH HEATER CORE,

CAR POWER SEAT, ELECTRIC SEAT, POWER SEAT WILL NOT WORK, SEAT WILL NOT GO FORWARD,



For all types of---------

Timing belt routing diagrams for cars and trucks?



                          

==========

For all types of --------

Drive belt routing diagrams for cars and trucks?




stalling issues:
Engine stalls, car stalls while starting, vehicle stalls while starting, Engine stalls and dies, Car stalls and stops,


CRUISE CONTROL Not working, cruise control replacing, troubleshooting cruise control problems,


TRANSMISSION PROBLEMS:

NO REVERSE ON TRANSMISSION

GEAR SHIFT ISSUES

Transmission fluid leak, transmission gears slip,


TRANSMISSION REPLACING AND TROUBLESHOOTING, INSPECTING TRANSMISSION COMPONENTS, TRANSMISSION FAILURES, OD WARNING LIGHT,


TRANSMISSION FLUID FILLING, WHERE TO FILL TRANSMISSION FLUID, AUTOMATIC TRANSMISSION FLUID, NO TRANSMISSION DIPSTICK,


WINDSHIELD WIPERS, WINDSHIELD WIPERS NOT WORKING,WIPER MOTOR MAKING NOISE,NO WIPERS,WIPER FLUID LEAKS,WIPER FUSE AND RELAY,


COOLANT LEAK ISSUES, COOLANT LEAK PROBLEMS, COOLANT SENSOR, LOW COOLANT,


BRAKE LIGHTS NOT WORKING, REPAIRING BRAKE LIGHTS, NO BRAKE LIGHTS,


CHECK ENGINE LIGHT,ENGINE WARNING LIGHT FLASHING,ENGINE LIGHT ON DASH,DASHBOARD WARNING LIGHT,ECM ERROR CODES,


DASHBOARD WARNING LIGHTS ARE ON, ENGINE LIGHT ON DASH,WARNING LIGHTS STEADY ON DASH,RESET DASH BOARD WARNING INDICATOR,


KEYFOB PROGRAMMING, REPROGRAMMING CAR KEY, KEYLESS ENTRY RESET,ANTITHEFT WILL NOT LET CAR TO START, ANTI THEFT ISSUES, KEYFOB NOT WORKING, KEYLESS ENTRY QUIT WORKING,


IGNITION KEY WILL NOT RELEASE, IGNITION KEY STUCK UP, KEY WILL NOT COME OUT OF IGNITION, FAULTY IGNITION KEY LOCK CYLINDER, REPLACING IGNITION CYLINDER,


HEATER ISSUES:

HEATER NOT BLOWING COLD,NO HOT AIR FROM HEATER,A/C BLOWS HOT AIR,A/C NOT BLOWING COLD, COLD AIR FROM HEATER,BLEND DOOR ACUTATOR CLOSED,HVAC UNIT NOT OPERATING,



HEATER NOT BLOWING COLD,NO HOT AIR FROM HEATER,A/C BLOWS HOT AIR,A/C NOT BLOWING COLD, COLD AIR FROM HEATER,BLEND DOOR ACUTATOR CLOSED,HVAC UNIT NOT OPERATING,



STEERING ISSUES:

POWER STEERING TROUBLESHOOTING, STEERING SQUEAKS, POWER STEERING FLUID LEAKS, FAULTY POWER STEERING PUMP, POWER STEERING NOT WORKING, POWER STEERING BELT,



VEHICLE STARTING ISSUE:

CAR NO START: ENGINE NOT TURNING OVER:





Sunday, March 31, 2013

Dodge RAM 3500 Quad Cab Oil Change Service

Dodge RAM over head display says perform service for an oil change.
How do you clear this?
Low oil warning
Another issue is check engine light flashes 10 times?

Vehicle Details:

Make: dodge
Model: RAM 3500 Quad Cab
Year: 2008
Engine: 6.7


oil change service


Expert's Reply:


How To Reset Oil Change Indicator?


The oil change reminder is easy to reset.

The Simple procedure Is As follows:---------

Turn the key on without starting the engine. Press the accelerator to the floor and release it three times within ten seconds and then turn the key off. This will reset the oil life monitor. Oil life is calculated based on driving conditions so this monitor will be more accurate than going by a sticker based on mileage.


Why This Oil Service Message Is Indicated?What's The Exact Reason for This message On Overhead Display?

The perform service message is displayed when routine maintenance is needed. On the 6.7 engine when the perform service message is displayed it is time to clean the EGR valve, EGR cooler, and replace the closed crankcase ventilation filter on top of the valve cover.


Ok,But How To Reset The Maintenance Monitor?

To reset the maintenance monitor you will need to turn the key on, press and release the brake pedal twice, then press and release the accelerator twice, and then turn the key off.


Ok,And What About Engine Light Flashing 10 Times On Dash?

I Will Say Its Not To Worry Issue.The flash code feature went away on Chrysler products after the 1996 model year so the flashing engine light you are seeing isn't anything to be concerned with. The status of the engine light is now used for emissions test readiness monitoring.

Suppose if you turn the key ON and 

  • The light flashes that means all monitors have not ran and passed since the last memory reset. 
  • If the light goes out that means monitors have ran and no codes are stored,
  • If the light stays on constantly then that means codes are stored. 
Still i suggest to get your vehicle ECM scanned.If there is any other problem,the error code will show.
  • Since your engine light is staying off and nothing shows up with a scan tool you know no codes are stored.


OK,How To Deal With The EGR Cooler And The EGR Valve?
Should I clean Them Or Replace The Parts Directly?

EGR valve,EGR cooler and Crankcase diagram
  1. Breather Cover
  2. EGR Cooler
  3. Crankcase Pressure Sensor
  4. Fuel Line Shield
  5. WIF Drain
  6. WIF Sensor
  7. CCV Drain Lines
  8. Fuel Pump
  9. EGR Airflow Control Valve
  10. EGR Valve
They need to be removed for the cleaning. 

Ok,Where Are This Parts located?
The valve is over on the left side on the air intake. On the top, front of the engine you'll see the round metal tube going from one side of the engine to the other, this goes to the EGR valve over on the left side. The valve is held to the air intake with four 10mm bolts. To clean the valve it would need to be removed and then a solution of Mopar EGR cleaner and water mixed up is used to clean the inside of the valve.

Ok,And Where Is The EGR Cooler Unit Located?

The EGR cooler is the large unit mounted to the top of the exhaust manifold on the right side of the engine. It has a two bolt flange all the way in the back where the exhaust flows in, it flows through the cooler, through the cooler bypass valve, and then it connects to the EGR tube I mentioned. The cooler would need to be removed, one end of it sealed off and a mixture of the EGR cleaner is used to fill the cooler and let it sit, then it gets rinsed out with hot water to remove soot buildup.

Ok,and How To Replace Crankcase Filter?

To replace the crankcase filter you would need to remove the small cover on the top/front of the engine, the coil cap, and then the plastic cover on the top of the valve cover. 
There are about eight 8mm bolts to remove, the cover comes off and the filter can be lifted out and replaced.


This Details Will Help.
Thanks.

ALSO VIEW THIS RELATED:

For Car parts and diagrams:

CAR MANUAL GUIDE
                 
FOR FREE MANUALS AND GUIDES: ---
Car repair guide?


For all types of car repair help:



Car Backfires

For car repair How to guides:


OVERHEATING: Radiator Fan Not Working

Engine Cooling Fan not Working


"Radiator fan"  "Engine Fan"  "COOLING FAN WILL NOT TURN OFF"

LIFT GATE / TAIL GATE ISSUES

TRUNK WILL NOT OPEN


CAR ALARM ISSUES


Car starter removal, Starter motor testing, Starter repairs, Starter solenoid, Starter wiring,


DOOR PANEL REMOVAL, car door panel, door panel components, front door panel, rear door panel,


HEATER CORE REPLACEMENT, HEATER CORE REMOVAL, TROUBLESHOOT HEATER CORE, FLUSH HEATER CORE,

CAR POWER SEAT, ELECTRIC SEAT, POWER SEAT WILL NOT WORK, SEAT WILL NOT GO FORWARD,



For all types of---------

Timing belt routing diagrams for cars and trucks?



                          

==========

For all types of --------

Drive belt routing diagrams for cars and trucks?




stalling issues:
Engine stalls, car stalls while starting, vehicle stalls while starting, Engine stalls and dies, Car stalls and stops,


CRUISE CONTROL Not working, cruise control replacing, troubleshooting cruise control problems,


TRANSMISSION PROBLEMS:

NO REVERSE ON TRANSMISSION

GEAR SHIFT ISSUES

Transmission fluid leak, transmission gears slip,


TRANSMISSION REPLACING AND TROUBLESHOOTING, INSPECTING TRANSMISSION COMPONENTS, TRANSMISSION FAILURES, OD WARNING LIGHT,


TRANSMISSION FLUID FILLING, WHERE TO FILL TRANSMISSION FLUID, AUTOMATIC TRANSMISSION FLUID, NO TRANSMISSION DIPSTICK,


WINDSHIELD WIPERS, WINDSHIELD WIPERS NOT WORKING,WIPER MOTOR MAKING NOISE,NO WIPERS,WIPER FLUID LEAKS,WIPER FUSE AND RELAY,


COOLANT LEAK ISSUES, COOLANT LEAK PROBLEMS, COOLANT SENSOR, LOW COOLANT,


BRAKE LIGHTS NOT WORKING, REPAIRING BRAKE LIGHTS, NO BRAKE LIGHTS,


CHECK ENGINE LIGHT,ENGINE WARNING LIGHT FLASHING,ENGINE LIGHT ON DASH,DASHBOARD WARNING LIGHT,ECM ERROR CODES,


DASHBOARD WARNING LIGHTS ARE ON, ENGINE LIGHT ON DASH,WARNING LIGHTS STEADY ON DASH,RESET DASH BOARD WARNING INDICATOR,


KEYFOB PROGRAMMING, REPROGRAMMING CAR KEY, KEYLESS ENTRY RESET,ANTITHEFT WILL NOT LET CAR TO START, ANTI THEFT ISSUES, KEYFOB NOT WORKING, KEYLESS ENTRY QUIT WORKING,


IGNITION KEY WILL NOT RELEASE, IGNITION KEY STUCK UP, KEY WILL NOT COME OUT OF IGNITION, FAULTY IGNITION KEY LOCK CYLINDER, REPLACING IGNITION CYLINDER,


HEATER ISSUES:

HEATER NOT BLOWING COLD,NO HOT AIR FROM HEATER,A/C BLOWS HOT AIR,A/C NOT BLOWING COLD, COLD AIR FROM HEATER,BLEND DOOR ACUTATOR CLOSED,HVAC UNIT NOT OPERATING,



HEATER NOT BLOWING COLD,NO HOT AIR FROM HEATER,A/C BLOWS HOT AIR,A/C NOT BLOWING COLD, COLD AIR FROM HEATER,BLEND DOOR ACUTATOR CLOSED,HVAC UNIT NOT OPERATING,



STEERING ISSUES:

POWER STEERING TROUBLESHOOTING, STEERING SQUEAKS, POWER STEERING FLUID LEAKS, FAULTY POWER STEERING PUMP, POWER STEERING NOT WORKING, POWER STEERING BELT,



VEHICLE STARTING ISSUE:

CAR NO START: ENGINE NOT TURNING OVER:


@